![]() ![]() It is normal for the parking brake light to flash, indicating that the brake cannot be used while the calipers are in this service mode.ĭo not operate the EPB switch or continue with the Close Rear Parking Brake step until the rear brakes are reassembled!Īfter the result of Not Running (or Finished Correctly) appears click Ĭycle the Parking Brake ON and back OFF again using the switch in the vehicle while holding the brake pedal.Ĭheck for fault code(s) before the test drive.Replace "test drive" with "bedding". The caliper pistons do not move back into the caliper, they must be pushed in using a hand tool. ![]() Turn ignition off and leave battery charger connected. The brake calipers will then open, allowing the pads to be changed.Īfter the result of Finished Correctly appears click Cycle the Parking Brake ON, then OFF first. VCDS 18.9.0 vag com vag diagnostic cable is latest version genuine Ross Tech VCDS Hex+CAN USB Interface 1:1 clone which support update online. ![]() Connect a battery charger as per repair manual. ALL rear brake components are assembled. It is strongly recommended to run a full Auto-Scan to check for any preexisting faults! If you skip any prerequisites or other steps here, you are likely to experience "issues" for which no documented resolutions exist, in which case we will not be able to help you resolve them. Do not perform any of these Basic Settings while the brakes are disassembled! Opening, closing, function tests, and otherwise cycling the Electronic Parking brakes should only be done with the pads and calipers properly installed on the rotors.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |